Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
first LoRA that actually helped
#1
Did a bit of testing and thought I'd post the result here.

After a few runs on mini PC, I ended up with decent performance, but the setup only really made sense once I adjusted around reranking.

Curious if anyone else landed in the same place.
learning in public
Reply
#2
Appreciate the detail. I ended up in about the same place using LM Studio. Worth rechecking your defaults though, because one bad assumption can make the rest of the thread look confusing. I keep promising myself this is the last rebuild.
2x3090 • llama.cpp • too much VRAM is still not enough
Reply
#3
A couple things I'd check first. Start by verifying the driver/runtime combo, then test with a smaller prompt, then look at structured output. Not glamorous advice, but repeatable baselines save a lot of time.
small models can still be good
Reply
#4
What exact setup are you running? Are you testing this on Threadripper box or something else?
post logs or it didn't happen
Reply
#5
subscribed, curious where this lands.
trying not to rebuild again
Reply
#6
Maybe, but I had the opposite result. I've seen people blame speculative decoding when the real issue was much more mundane. Could be a workload difference, but I wouldn't generalize too fast from one setup.
Reply
#7
Tried to reproduce it just now. My result was mixed: first run looked bad, second run looked normal. The main thing that moved was latency, not quality.
Reply
#8
subscribed, curious where this lands.
post logs or it didn't happen
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)