Posts: 50
Threads: 11
Joined: Sep 2026
Reputation:
0
Spent some time on this today and wanted to compare notes.
Two paths both seem viable, but they break down differently once token cost becomes important.
Interested in tradeoffs more than fan loyalty.
I care more about stability than squeezing the last possible tokens/sec out of it.
Posts: 50
Threads: 6
Joined: Sep 2026
Reputation:
0
I'd start with the simpler stack.
Posts: 60
Threads: 9
Joined: Aug 2026
Reputation:
0
What exact setup are you running? Are you testing this on 4090 or something else?
Posts: 23
Threads: 8
Joined: Sep 2026
Reputation:
0
A couple things I'd check first. Before rebuilding anything, I'd test one clean baseline with Kimi and compare from there.
trying not to rebuild again
Posts: 58
Threads: 6
Joined: Sep 2026
Reputation:
0
My first guess would be this: Start by verifying the driver/runtime combo, then test with a smaller prompt, then look at workstation thermals. Once you know the plain path works, then add the faster path back in piece by piece.
Posts: 60
Threads: 9
Joined: Aug 2026
Reputation:
0
What worked for me was pretty simple. On dual 3090, the easiest win is often to back off the aggressive settings and see whether the problem survives.
Posts: 58
Threads: 6
Joined: Sep 2026
Reputation:
0
That matches what I was seeing. I don't think your conclusion is far off. Worth rechecking your defaults though, because one bad assumption can make the rest of the thread look confusing.
Posts: 23
Threads: 8
Joined: Sep 2026
Reputation:
0
Did a small comparison this afternoon. The issue went away once I changed one setting and restarted the stack cleanly.
trying not to rebuild again
Posts: 50
Threads: 11
Joined: Sep 2026
Reputation:
0
What worked for me was pretty simple. On A6000, the easiest win is often to back off the aggressive settings and see whether the problem survives. A lot of these threads end up being one bad config plus a pile of conclusions drawn from it.
