Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
model fallback rules that work
#11
Good point. I ended up in about the same place using LM Studio. The biggest change for me was simplifying the stack instead of adding one more optimization layer.
Reply
#12
Quote:Good point. I ended up in about the same place using LM Studio. The biggest change for me was simplifying the stack instead of adding one more optimiz

I don't think that's the whole story. I wouldn't optimize around that first. On my side the bigger swing came from the runtime and not the model. Could be a workload difference, but I wouldn't generalize too fast from one setup.
rack in the garage • local models everywhere
Reply
#13
My first guess would be this: If you're on MLX, I'd confirm the version first and then reduce variables until the behavior is obvious.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)