Posts: 55
Threads: 7
Joined: Aug 2026
Reputation:
0
Spent some time on this today and wanted to compare notes.
Two paths both seem viable, but they break down differently once token cost becomes important.
What would you pick if you had to live with it for a few months?
still benchmarking everything
Posts: 40
Threads: 9
Joined: Sep 2026
Reputation:
0
Did a small comparison this afternoon. The issue went away once I changed one setting and restarted the stack cleanly. The surprise was that memory pressure showed up before throughput collapsed.
Posts: 52
Threads: 6
Joined: Aug 2026
Reputation:
0
Good point. I don't think your conclusion is far off. The biggest change for me was simplifying the stack instead of adding one more optimization layer.
Posts: 51
Threads: 3
Joined: Sep 2026
Reputation:
0
subscribed, curious where this lands.
Posts: 43
Threads: 5
Joined: Sep 2026
Reputation:
0
What worked for me was pretty simple. If you're on SGLang, I'd confirm the version first and then reduce variables until the behavior is obvious. Once you know the plain path works, then add the faster path back in piece by piece.
Posts: 123
Threads: 18
Joined: Sep 2026
Reputation:
0
that fixed it for me too.
post logs or it didn't happen
Posts: 43
Threads: 5
Joined: Sep 2026
Reputation:
0
I'd approach it in a boring order. Before rebuilding anything, I'd test one clean baseline with Gemma and compare from there. A lot of these threads end up being one bad config plus a pile of conclusions drawn from it.
Posts: 123
Threads: 18
Joined: Sep 2026
Reputation:
0
Quote:I'd approach it in a boring order. Before rebuilding anything, I'd test one clean baseline with Gemma and compare from there. A lot of these threads e
Tried to reproduce it just now. On B200 with vLLM, I saw basically the same behavior.
post logs or it didn't happen
Posts: 63
Threads: 1
Joined: Sep 2026
Reputation:
0
Quote:[quote]I'd approach it in a boring order. Before rebuilding anything, I'd test one clean baseline with Gemma and compare from there. A lot of these th
My first guess would be this: Before rebuilding anything, I'd test one clean baseline with Phi and compare from there. Once you know the plain path works, then add the faster path back in piece by piece.
I'm happy to test one more variant if you want a second data point.
still benchmarking everything
Posts: 31
Threads: 6
Joined: Sep 2026
Reputation:
0
I'd approach it in a boring order. If you're on MLX, I'd confirm the version first and then reduce variables until the behavior is obvious.
trying not to rebuild again