Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jetson still a thing with MLX
#1
Thought I'd post a small recipe because a lot of threads ask similar things.

This isn't revolutionary, but the combination of MLX and M3 Max felt surprisingly usable once I tuned around KV cache pressure.

If someone wants the exact settings I can clean them up and post them.

This is mostly for local work rather than public serving.
Reply
#2
Quote:Thought I'd post a small recipe because a lot of threads ask similar things.

Need a little more detail here. Is this local-only or are you routing anything externally?
Reply
#3
Quote:
Quote:Thought I'd post a small recipe because a lot of threads ask similar things.

following this because I'm in the same boat.
team red, team patient
Reply
#4
Tried to reproduce it just now. My result was mixed: first run looked bad, second run looked normal. I expected the model choice to matter more than it did.
curious and caffeinated
Reply
#5
A couple things I'd check first. If you're on LM Studio, I'd confirm the version first and then reduce variables until the behavior is obvious. A lot of these threads end up being one bad config plus a pile of conclusions drawn from it.
rack in the garage • local models everywhere
Reply
#6
subscribed, curious where this lands.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)