Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
what are you all running this week for Phi
#11
Good point. That matches what I saw on 7900 XTX. The biggest change for me was simplifying the stack instead of adding one more optimization layer.
Reply
#12
Good point. The pattern around speculative decoding has been pretty similar for me.
Reply
#13
following this because I'm in the same boat.
Reply
#14
I tested this tonight. On GB200 with MLX, I saw basically the same behavior. The surprise was that memory pressure showed up before throughput collapsed.

There are a few different conversations hiding inside this thread, so being explicit about the goal helps.
Reply
#15
Quote:I tested this tonight. On GB200 with MLX, I saw basically the same behavior. The surprise was that memory pressure showed up before throughput collaps

Did a small comparison this afternoon. I couldn't reproduce the slowdown until I pushed context much higher.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)