+- Inference (https://www.datasculpting.ai/inference)
+-- Forum: Miscellaneous Discussion (https://www.datasculpting.ai/inference/forumdisplay.php?fid=24)
+--- Forum: News & Industry (https://www.datasculpting.ai/inference/forumdisplay.php?fid=26)
+--- Thread: driver/framework news roundup (/showthread.php?tid=752)
driver/framework news roundup - deepseeked - 10-04-2026
Spent some time on this today and wanted to compare notes.
Two paths both seem viable, but they break down differently once continuous batching becomes important.
Trying to avoid rebuilding the whole thing twice.
Re: driver/framework news roundup - mangowire - 10-04-2026
What worked for me was pretty simple. Before rebuilding anything, I'd test one clean baseline with Qwen and compare from there.
Re: driver/framework news roundup - amberrunner - 10-06-2026
What worked for me was pretty simple. On A6000, the easiest win is often to back off the aggressive settings and see whether the problem survives. Once you know the plain path works, then add the faster path back in piece by piece.
There are a few different conversations hiding inside this thread, so being explicit about the goal helps.
Re: driver/framework news roundup - batchyard - 10-06-2026
Quote:What worked for me was pretty simple. On A6000, the easiest win is often to back off the aggressive settings and see whether the problem survives. Onc
What worked for me was pretty simple. If you're on TensorRT-LLM, I'd confirm the version first and then reduce variables until the behavior is obvious. Not glamorous advice, but repeatable baselines save a lot of time.
Re: driver/framework news roundup - deepseeked - 10-06-2026
same here on my side.
Re: driver/framework news roundup - dockriver - 10-07-2026
Thanks, that helps. I ended up in about the same place using vLLM. Worth rechecking your defaults though, because one bad assumption can make the rest of the thread look confusing. Turns out 'just one more test' was a lie.
Re: driver/framework news roundup - fastlab - 10-07-2026
I'd approach it in a boring order. Start by verifying the driver/runtime combo, then test with a smaller prompt, then look at structured output. A lot of these threads end up being one bad config plus a pile of conclusions drawn from it.